AU Engineering

Aarhus University Seal
 ingenioer.au.dk/en About us Laboratories & Workshops Ordering print Start-up to design prints

Start-up to design prints

Before you print make the following considerations:

Physical frames on the print

Size, shape and mounting holes (should it be able to fit in a box)

Power consumption of the design
(Are there areas where the power usage is especially high? And what about supply?)

Typical course width 0.5 mm

Which components should I use (footprint)

Physically measure the component or find a datasheet

Insulation distances are areas with extra requirements

(possibly 230V for low voltage)
 

Typical insulation distance 0.4 mm

Revised 26.05.2023
-
Kontakt Elektronikværkstedet